Thingiverse
Angle Bracket 20mm w/ tabs
von Traevanon
11
Downloads
9
Likes
0
Makes
Just added side holes and guide tabs to the previous design.
Print with the 45 degree side down, with a brim and support on anything above 46 degrees.
2/27 - Widened the tabs a little for a more positive alignment.
Print with the 45 degree side down, with a brim and support on anything above 46 degrees.
2/27 - Widened the tabs a little for a more positive alignment.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
