Angular Control Panel Mount

MAJOR EDIT! I decided to make a large format delta printer with my grandson and the display became a problem to mount with the large dimensions of the printer. I created the original SD card holding mount to be attached to the top 20mm X 20mm rail of a delta printer. With a 42" build height and sitting on a 20-30 inch high table that was not going to work. The printer also requires the rigidity of the adjacent wall to hold down excessive motion so the flat side out placement was not optimal. This is what I came up with to make it all work. It won't be much use to you unless you do the project my way but here it is if anyone in the community that might need it. The placement and angle of the display mount will require you to elevate the bottom edge of the lower 20mm X 20mm extrusion at least 1.1" off the table top. The machine leg leveling mounts shown in the drawing are available here in my models for you to use if you like. They also act as table levelers. My apologies to an