Thingiverse
Angular Trophy (Customizable)
von worfsforehead2
59
Downloads
35
Likes
0
Makes
A trophy I made for an "angular fixit week" to give out to the top fixers.
The trophy is based on the angular-logo-as-a-cube school of thought, rather than the angular-logo-as-a-shield camp ;P ! Therefore, the center of the trophy ring is a partially 3d-projected cube. This gives it the illusion of perspective when viewed from the right angle, just like angular logo itself does. The code is not perfectly clear, but, you may be interested in reading through it or copying the concept in your own designs!
I suggest you print it in two parts, especially if you can print multiple top pieces at once. That will help with the overhang. They should fit together afterwards. However, you can certainly try to print in one go.
Most everything is allowed to be customized in the "advanced" tab in the customizer, but beware of dragons. I didn't really design that stuff to be customized.
The trophy is based on the angular-logo-as-a-cube school of thought, rather than the angular-logo-as-a-shield camp ;P ! Therefore, the center of the trophy ring is a partially 3d-projected cube. This gives it the illusion of perspective when viewed from the right angle, just like angular logo itself does. The code is not perfectly clear, but, you may be interested in reading through it or copying the concept in your own designs!
I suggest you print it in two parts, especially if you can print multiple top pieces at once. That will help with the overhang. They should fit together afterwards. However, you can certainly try to print in one go.
Most everything is allowed to be customized in the "advanced" tab in the customizer, but beware of dragons. I didn't really design that stuff to be customized.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
