Animal Silhouette Drawer Knobs

Drawer knobs featuring silhouette's of different animals! The knobs are 36mm diameter, with holes sized to fit a #8-32 screw (the typical screw used for drawer knobs in North America). There is one of each animal on the main plate, choose the one(s) you want and duplicate as needed / desired, and just delete the rest. Available Animals: Whale, Flamingo, Scorpion, Kangaroo, Lobster, Octopus, Jellyfish, Elephant, Toucan, Starfish, Crab, Lion, Fish, Cat (stretching), Turtle, Seahorse, Llama, Koala, Rhino. Designed for print without AMS! When slicing, add a pause at layer 175 (assuming 0.16mm layer height, which I recommend). Swap your filament, then finish the print.Tip:/**Use a large Brim** - Recommended ~25mm. If you don't it is possible for the knob to pull off during print since the contact area with the plate isn't that big. This is because I made this to not require AMS, so the colour switch needed for the silhouette's had to be on the top.