Another Eagle!

From the same creator of award winning model Another Bat! the all new Another Eagle! is here.These Eagles are so addictive. I couldn't stop printing them and finding the ideal balance. I hope you also enjoy. Printing recommendationEagle - Infill at 100%.Print the Eagle with the wings touching the hotbed (belly up). In this way, you will need to set up a support for the Eagle's head - use normal structure only where touching the hotbedHotbed adherence skirt or brim (if your prints use to warp). I printed using a ender 3-S1 with Sonic Pad at 160mm/sec with no problem (deep blue PLA+). You may scale at your convince, but larger is easier to achieve equilibrium.Stand - Use Brim (at least 10mm) for bed adhesion. If you iron (Cura's feature) the last top layer, you will get smooth balance. After printing the Eagle, bend its wings downward approximately 30 degreed (see above pictures) - use a hot gun or heat from the stove fire (with care - only a little is enough - do not overheat). It will be necessary for balance.