Thingiverse
Anycubic Kossel BL touch mount
von dacan
1
Downloads
0
Likes
0
Makes
Base on this design: https://www.thingiverse.com/thing:4927021
I have some trouble using this model because bltouch too close to my bed, so it can drag print model.
I move it up about z+ 1.5mm and from y- 1mm to make room for bltouch cable jack behind
so setting is: nozzle to probe offset (0, -37, XX)
in my case I setting in marlin (0, -37, -5) and after probe wizard. it set down to (0, -37, -1.23)
I have some trouble using this model because bltouch too close to my bed, so it can drag print model.
I move it up about z+ 1.5mm and from y- 1mm to make room for bltouch cable jack behind
so setting is: nozzle to probe offset (0, -37, XX)
in my case I setting in marlin (0, -37, -5) and after probe wizard. it set down to (0, -37, -1.23)
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
