Aperture Light

This 3D Printed Aperture Light is easy to build and will come in different versions. For now there is just the version with bearings.I will upload a version without bearings and threaded inserts as soon as possible! You can also use the Bambu Lab LED kit instead of the NodeMCU, just keep the input connector accessable so you can attach the bambu controller. Did not try it myself though. Preperation:Flash a NodeMCU Lolin V3 Module ESP8266 with WLED, you can find how to this here.Screw the upper part of the LED profile to the lower part with a 20mm M3 screw.Cut a LED strip to the length of the 3D printed LED profile.Solder short wires on the first stripe glue it in place and then solder the second one when cables go through their holes.Crimp the signal wire to connect it to the NodeMCU, connect 5V and GND cable to theHow to assemble:Put the base in front of you and insert the threaded inserts into the 7 holesPut a power input in the middle whole, its made for 9mm sockets but you can also