Thingiverse
Apple Magic Keyboard 2 risers
von Keecat
51
Downloads
37
Likes
1
Makes
Yo there!
So, I wanted to be able to use my keyboard and the trackpad for my Mac in the same way that my laptop is set up, but the dang chord to the trackpad was always in the way, so I made this spacer!
The risers add about a centimeter to the height of the keyboard, which is just enough to make the edge flush with the trackpad. I also think the added height makes for a more comfortable typing experience.
The risers require no support and are universal to either side, so print two and you are good to go.
On a side note: they also fit the dimensions of the trackpad itself so if you wanted to raise that up, for some reason, you could, I guess.
So, I wanted to be able to use my keyboard and the trackpad for my Mac in the same way that my laptop is set up, but the dang chord to the trackpad was always in the way, so I made this spacer!
The risers add about a centimeter to the height of the keyboard, which is just enough to make the edge flush with the trackpad. I also think the added height makes for a more comfortable typing experience.
The risers require no support and are universal to either side, so print two and you are good to go.
On a side note: they also fit the dimensions of the trackpad itself so if you wanted to raise that up, for some reason, you could, I guess.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
