Archery Spin Wing Vane Clamp

Tool to clamp spin wing vanes to arrow shaft

Added a _V2 version that should release the vane easier. Insert vane, add tape, then rotate forwards to clamp(for right hand vanes).

For the clamp:
Tape the Vane, then peel back part of the backing tape.
Insert vane into clamp slot
Rotate clamp against shaft
Hold down with 2 fingers and rotate the clamp back to release the vane.

Use the Tape Guide to draw guideline 120 degrees apart

Attach the Hex Guide to the front part of the shaft to keep the shaft level and to help rotate it 120 degrees per vane.


Read the Misc Print settings:
Print Vertically

Axle is printed in place - gently rotate to separate the 2 halves. It should rotate freely afterwards.
The Bore vs Axle (7.5mm vs 6mm) may have to be adjusted to reduce play.

You may have to scale for different Arrow Shaft Spines and printers - These worked for
Avalon Classic 4.2mm/1100 Spine(5.2mm OD) shafts, but not for 700 Spine(5.5mm OD)