Thingiverse
Arrow Fletching Jig
von Nickj_UK
0
Downloads
2
Likes
0
Makes
A simple jig to aid arrow fletching.
Made to work with 6-8mm diameter shafts and up to 10cm long fletchings (max 1mm thickness)
There is a spacer to change the nock to fletch distance which is 12mm in lengthto be used as is or rescaled to change the length to suit your needs.
I printed this in ASA mainly because it was what I had at the time but PLA, PLA+ would work equally well but it really doesn't matter as this should print fine in most common materials.
I would no reccommend using materials that are prone to strining like PETG as the slot for holding the fletchings might be difficult to clean out.
Made to work with 6-8mm diameter shafts and up to 10cm long fletchings (max 1mm thickness)
There is a spacer to change the nock to fletch distance which is 12mm in lengthto be used as is or rescaled to change the length to suit your needs.
I printed this in ASA mainly because it was what I had at the time but PLA, PLA+ would work equally well but it really doesn't matter as this should print fine in most common materials.
I would no reccommend using materials that are prone to strining like PETG as the slot for holding the fletchings might be difficult to clean out.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
