Thingiverse
Arrow Nock
von T__K
37
Downloads
32
Likes
0
Makes
Print at 101% / 102% !!!
remove all remaining glue attached
for me, it worked out fine at a 101%, without any need for glueing
Even I know there already are a lot of other nocks around, ....in my case (schaft a little scattered at the end) this works better for me, maybe you like it ;)
remove all remaining glue attached
for me, it worked out fine at a 101%, without any need for glueing
Even I know there already are a lot of other nocks around, ....in my case (schaft a little scattered at the end) this works better for me, maybe you like it ;)
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
