Thingiverse
Arturia Keylab Essential Riser
door rasmithuk
13
Downloads
12
Likes
0
Makes
Just a quick model to raise my Arturia Keylab Essential up enough to clear my keyboard.
Nothing fancy, just a short tower with a recess at the top where you can sit the feet of the keyboard in so it doesn't slide off.
The recess is sized to accept a 42mm diameter foot that's at least 2mm deep, any shorter and it will sit on top, rather then inside.
All angles are less than 45 degrees so it should print without supports on FDM printers.
The one I've printed were done so on a Creality Ender 3 with standard PLA, no raft or supports.
Nothing fancy, just a short tower with a recess at the top where you can sit the feet of the keyboard in so it doesn't slide off.
The recess is sized to accept a 42mm diameter foot that's at least 2mm deep, any shorter and it will sit on top, rather then inside.
All angles are less than 45 degrees so it should print without supports on FDM printers.
The one I've printed were done so on a Creality Ender 3 with standard PLA, no raft or supports.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!