Thingiverse
Atomstack Filament Spool Holder
by ESchlicher
3
Downloads
6
Likes
0
Makes
This spool holder is designed to be very simple to 3d print and is able to be laser cut
If laser cut, I recommend using 0.25In thick material
For the pin, if lasercut, use at Maximum 0.165 in thick material. A popsicle stick or two should work for the pin if you are laser cutting.
If laser cut, I recommend using 0.25In thick material
For the pin, if lasercut, use at Maximum 0.165 in thick material. A popsicle stick or two should work for the pin if you are laser cutting.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!