AtomStack LASER interior

This 3D-printed decorative object is designed to illuminate the AtomStack logo and laser sections using an integrated LED system.

・Inspired by the F60: The switch is modeled after the F60 and is used to turn on the LEDs. https://atomstack.com/products/atomstack-f60-air-assist-set

・Illumination: The AtomStack logo and the laser area light up, creating a visually striking effect.

・LED Configuration: The setup includes 5 LEDs – 4 red LEDs for the logo and 1 blue LED for the laser section.

・Power Source: The object is powered by 2 AA batteries.

・Wiring Method: Clips are used in place of traditional wiring for simplicity.

・Wiring Reference: Please refer to the “AtomStack LASER interior (For wiring check).stl” file to check the wiring method.

・Resistor: A 220Ω resistor is included (adjust according to the specific LEDs used).