Audio Component Riser Feet

Very Basic Riser Feet to elevate your audio component(s). Allows for more cooling and airflow between audio equipment. These are designed to allow existing feet on a component to set inside the riser feet. The specs are 30mm high, with an inset of 8mm, giving your component a total of 22mm elevation/rise. These are designed to fit audio components that have 52mm diameter feet or smaller. The outer diameter is 56 mm, but you can scale it to whatever diameter and height you like.

With 15% infill cubic pattern, I was able to stand on one foot and it had no issues supporting my weight.

*note There is no added sound isolation with these feet. Whatever your existing feet have for sound isolation, will be utilized. You could easily add rubber feet on the bottom of these to add further sound isolation if needed.

These take about 2.5 hours each to print with my Ender 3. I tried to model some with a spoke-type hub in the center rather than infill thinking this would take less t