Thingiverse
Auto bed leveling sensor bracket
von TRAXA
136
Downloads
76
Likes
0
Makes
A very simple bracket for mounting a capacitive or inductive auto bed leveling sensor to the Creality printer range.. Well, some of them at least!
The bracket mounts onto the fan shroud, using existing slots, and two M3 x 12 screws, 4 washers and 2 nyloc nuts..
There is ample adjustment for any 12mm diameter probe..
Currently using an inductive sensor, but I may go with a capacitive one if I fit a glass bed.
The bracket mounts onto the fan shroud, using existing slots, and two M3 x 12 screws, 4 washers and 2 nyloc nuts..
There is ample adjustment for any 12mm diameter probe..
Currently using an inductive sensor, but I may go with a capacitive one if I fit a glass bed.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
