Thingiverse
Auto Level Bracket
von Mac_za
4
Downloads
4
Likes
0
Makes
This will suit the following extruder http://www.thingiverse.com/thing:678089.
One can use either a inductive or capacitive probe with a 18mm diameter. I previously made this auto level bracket, http://www.thingiverse.com/thing:1273042.
One can use either a inductive or capacitive probe with a 18mm diameter. I previously made this auto level bracket, http://www.thingiverse.com/thing:1273042.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!