Thingiverse
Automatic Fish Feeder
von rhaas79
10
Downloads
2
Likes
0
Makes
This is an automatic fish feeder based on a Raspberry Pi Zero and an SG90 servo.
It features a sliding door actuated by the servo to drop food into an aquarium below based on open time and sliding speed.
You will need 4 2.5mm x 8mm screws to assemble the hopper and Pi mounting plate to the baseplate.
It features a sliding door actuated by the servo to drop food into an aquarium below based on open time and sliding speed.
You will need 4 2.5mm x 8mm screws to assemble the hopper and Pi mounting plate to the baseplate.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!