Slicer Discord
Autopia – 3D-Druckmodell von MakerWorld MakerWorld
Vehicles

Autopia

von LoboCNC · Vehicles
15 Downloads
30 Likes
0 Makes
Zum Modell
What could be more utopian than automobiles! In Disneyland, circa 1955! For the uninitiated, the Autopia ride at Disneyland consisted of very slow, miniature cars that you got to drive around on a closed track. To keep you from driving off into the Pirates of the Caribbean, your wheels straddled a curb running down the middle of the track. I remember riding this back in the ‘60’s. Of course as a little kid, I hadn't figured out that after turning, you had to straighten the steering wheel back if you wanted to go straight again. Hence, I went the entire ride grinding along the curb, one side or the other. This tabletop version is much more fun than that.This version uses a serpentine track that captures a long string of 6mm balls - Airsoft BB's, to be specific. At one end of the circuit, the balls wrap around the dial, which essentially is the inner race of a ball bearing. Rotating the dial while pressing down gently forces the balls to recirculate through the entire track circuit.You w
Kategorie
Vehicles
Quelle
MakerWorld
Veröffentlicht
Aktualisiert
Was du zum Drucken brauchst: Mittel Niedrige Konfidenz
Warum?
Supports nötig
Einteilig Supports nötig Hardware nötig
Supports 2/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 1/3
Drucker
FDM / FFF
Dateiformat
STL
Material
Nachbearbeitung
Hardware
Software
Cura, PrusaSlicer o. Ä.
Gleicher Designer, mehr Plattformen

LoboCNC veröffentlicht auch auf

313 zusätzliche Modelle auf 1 weiteren Plattformen

Verifiziert durch übereinstimmende Modelltitel über Plattformen hinweg.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen