Thingiverse
Back Light Mount
von flowerking
16
Downloads
10
Likes
0
Makes
This is a mount for a back light on a recumbent bike. It is especially for the IX Red back light from Busch+Müller.
The mount consists of two parts. On the hinge-side the two part are connected with a thin tube of 2mm in diameter. On the other side, screw can be used with a thread-diameter of 3mm. I used a (metric) M3 thread and Nylon screws.
The mount consists of two parts. On the hinge-side the two part are connected with a thin tube of 2mm in diameter. On the other side, screw can be used with a thread-diameter of 3mm. I used a (metric) M3 thread and Nylon screws.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!