Thingiverse
Bag buckle / clip
von Lukefarloid
7
Downloads
6
Likes
0
Makes
A buckle or clip printed in PLA. Was designed for the chest strap of a bag, a fairly robust design.
Printed in PLA with no supports - quite a bit of bridging so make sure to have adequate cooling, you will probably need to go though the interior with a craft knife to remove any stray filament.
for 25- 30 mm strap but could be scaled to fit larger.
A even more heavy duty buckle could be made by scaling the design by ~150% in the z direction.
Printed in PLA with no supports - quite a bit of bridging so make sure to have adequate cooling, you will probably need to go though the interior with a craft knife to remove any stray filament.
for 25- 30 mm strap but could be scaled to fit larger.
A even more heavy duty buckle could be made by scaling the design by ~150% in the z direction.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!