Thingiverse
Bar Mounts - Hyperstack
von TheGreatGrezzy
1
Downloads
1
Likes
0
Makes
I designed these Bar Mounts for my custom 3d printer based on the Hypercube called the Hyperstack!
Simple bar mounts to keep different guiding rails in place. These guys work....but are a little imprecise and should probably be redesigned to fit the full width of the extrusion to line up a bit easier.
Check out my blog for the design process for this printer!
My blog
Full Printer is still WIP, but will get done.... eventually....
XY Joiner
X Carriage
E3d Mount
Simple bar mounts to keep different guiding rails in place. These guys work....but are a little imprecise and should probably be redesigned to fit the full width of the extrusion to line up a bit easier.
Check out my blog for the design process for this printer!
My blog
Full Printer is still WIP, but will get done.... eventually....
XY Joiner
X Carriage
E3d Mount
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!