Thingiverse
Engineering
Zum Modell
Barn Lock
15
Downloads
16
Likes
1
Makes
This is V1 of an old barn lock design. The tolerances are pretty loose, it prints just fine at 50% even. Ideally the pins will slide smoothly up and down in the case.
Here is where I saw the original design:
https://www.youtube.com/watch?v=4peBi5Bg7YQ
Here is where I saw the original design:
https://www.youtube.com/watch?v=4peBi5Bg7YQ
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
