Bart Ren

Bart Ren Along time ago on a printer far far away….. Printed in parts, NO AMS needed. Model is approx 12cm tall at 80% in the print profile for ease of assembley. Printing it smaller is possible however small parts will be difficult to print and assemble. Keep an eye out on my page for future releases comming up in the next few weeks; 📌 Recommended printing settings: Material: PLA Layer height: 0.16 mm Infill: 15% Nozzle: 0.4mm supports where nessesary - I have tried to make it so all have a surface contacting the plate however due to the detail and complexity of the modeling they sometimes require alot of support, so be aware and be carefull during support removal. Use a naked flame gentley and for short intervals to clean surfaces after removal Assembly – Recommended Method on multipart models Dry fit: Assemble all parts without glue to check alignment and fit. Cleanup: Lightly deburr edges and pegs where nessesary with a file/modeling tool to ensure uniform contact. All parts are t