Thingiverse
Basic Box
von SoarinVandenBerg
1
Downloads
3
Likes
0
Makes
This box uses 3x2mm magnets to keep the top on the bottom, and the other flat piece is to put on the lid to make sure it doesnt shear off. It has pretty big clearance so it wont matter what quality you put it at just make sure its under 3mm.
In the photo I used it to hold a small puzzle
In the photo I used it to hold a small puzzle
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!