Thingiverse
Basic Funnel
von rhin0xx
54
Downloads
34
Likes
0
Makes
This is the same funnel but orientated 180 degrees. At .3 and 0 infill it prints in less than an hour and a half and only uses 20ish grams. The original printed with supports takes over 6 and a half hours and 120ish grams.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
