Thingiverse
Basic Pan/Tilt (small camera)
door lucasjentsch
0
Downloads
0
Likes
0
Makes
Made with intent to use two Hitec HS-55 sub-micro servos (if these are large enough)
Print out each part and glue them together (this might require a bit of trimming as the tolerances are tight.)
The camera mount is supported at one end with a 2-56 x 1/4" machine screw and the other side is supported by the servo horn.
The assembly is attached to the base using the servo horn and two servo mounting screws.
Print out each part and glue them together (this might require a bit of trimming as the tolerances are tight.)
The camera mount is supported at one end with a 2-56 x 1/4" machine screw and the other side is supported by the servo horn.
The assembly is attached to the base using the servo horn and two servo mounting screws.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!