Thingiverse
Basic ruler
von schaeferle
0
Downloads
1
Likes
0
Makes
This is a ruler I designed a while ago when I was still using OpenSCAD.
This is designed to underline in two different ways (straight and wavy) and to measure up to 16cm.
Enjoy, Schaeferle
This is designed to underline in two different ways (straight and wavy) and to measure up to 16cm.
Enjoy, Schaeferle
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
