Basic V1 Windshield Mount

This is a pretty simple part... it just holds two screws at the right distance so that you can hang a Valentine One windshield mount from it...

Since this is intended to go into a car, and cars get hot... Don't use PLA. I used PETG, which works well.

It's printed with M3 threads, so you'll want to print at reasonably high detail levels, despite it being a simple part.

I grabbed two reasonably long M3 screws from my computer parts drawer, and then added two 2.5mm rubber gaskets to each screw. That leaves the mount with enough flexibility to handle reasonable variations in windshield angle... The mount goes between the two gaskets.