Thingiverse
Basic Wire/Cord Holder
von nebhead
4
Downloads
5
Likes
0
Makes
This thing was made with Tinkercad. Edit it online https://www.tinkercad.com/things/1vum91uDg9x
I created this very simple design to hold a wire to the brake controller in my Subaru, while the brake controller is not attached. This is helpful because otherwise the wire would hang down near the gas peddle which was bad - for obvious reasons.
I created this very simple design to hold a wire to the brake controller in my Subaru, while the brake controller is not attached. This is helpful because otherwise the wire would hang down near the gas peddle which was bad - for obvious reasons.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!