MakerWorld
Hand Tools
Go to Model
Beach Spade
397
Downloads
99
Likes
216
Makes
Print with 7 walls, 80% infill. Otherwise it might break. ABS/ASA if possibleCan be printed in 2 orientations-On the end, as shown in the photos-flat and sunk into the bed (Support is still needed) Print at a lower speed and higher temperature for best layer strength
Magmabow also publishes on
121 additional models across 1 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
