Thingiverse
Bear MMU2S sensor
von HayreAss
1
Downloads
0
Likes
0
Makes
Some modifications I made to make the MMU2S run right on my machine.
Been running well for over 6 months now on 2 machines.
Gives plenty of room for an LED on the sensor, and directs the light down so it's less annoying than with a hole in the front.
Of course you could always just drill a hole in the cap if you want to see more LED light.
Chimney is adjustable to fine tune the sensor.
You can also file a little off of the arm if you find you can't adjust it enough.
Been running well for over 6 months now on 2 machines.
Gives plenty of room for an LED on the sensor, and directs the light down so it's less annoying than with a hole in the front.
Of course you could always just drill a hole in the cap if you want to see more LED light.
Chimney is adjustable to fine tune the sensor.
You can also file a little off of the arm if you find you can't adjust it enough.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
