Bed Leveling Tool

An alternative to the typical sheet of paper that we use to level the bed. A precise height circumference with a handle for ease of use.

The recommended separation between the hotend and the bed is between 0.15 and 0.2 mm, so there are two files, one for each height.

WARNING!
---------------------
- The height of the printing layer must be carefully set so that the height of the circle part is correct.
- Be very careful when removing from bed, as it is very thin and can break easily
- I recommend printing with the "smoothing" option activated in Cura to give it greater resistance without affecting the thickness.
- If the circle is not completely filled as seen in the photos, there should be no problem if the thickness is what it should.
- The circular zone must pass without problem between the nozzle and the bed, or offer VERY little resistance.
- Do not use with the hotend still hot!

--------------------------------------------------------------------------------------