Thingiverse
bed-spring_4off (improved)
door MarcusWolschon
1
Downloads
2
Likes
0
Makes
bed-spring_4off from the RepRap Mendel has a very short area behind the teardrop that causes the part to fail if the filament does not stick perfectly.
I made that area somewhat longer to improve print-reliability.
The provided photo of this failure was done on a properly calibrated RepMan with 0.25mm layer-heigh and usualy extremely good prints. So
I guess this issue is much worse on the majority of RepRaps and Makerbots.
I made that area somewhat longer to improve print-reliability.
The provided photo of this failure was done on a properly calibrated RepMan with 0.25mm layer-heigh and usualy extremely good prints. So
I guess this issue is much worse on the majority of RepRaps and Makerbots.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!