Bibi ball

Transforming ball based on Bibi (if you know who that is, good, if not, let's just say it's a cat).
The transformation is based on minicon Dead End from Transformers Armada

Printing:

-0.1mm layer height
-nozzle temp: 200 degrees Celsius
-bed temp: 60 degrees

the rest is just what Cura has as standard for the ender 3. This is just what worked for me without much testing, so you'll probably have to change things

Post processing:
this part is relatively simple, just opening up the holes a bit due to the elephant's foot and shaving away/sanding any plastic that might interfere. Also I recommend sanding about a millimeter from the side of the pegs that looks at the print bed

Assembly:
There are two halves, the back one has the arms, horns, gun, and tail. The front half has the legs. the few pieces that aren't attached with pegs (ankles, horns, and tail) go together with pins, In my case I used paperclips, but I believe anything that fits should work. Things might need