BIBO Touch X Filament Guide

If your tired of not being able to use your filament switches because the filament keeps slipping off the side this is the solution. To install use a 14mm wrench to unscrew the guide tube fittings. Also, you will want to remove the plastic clamp around the wire harness as its no longer needed with this part. This part squeezes the wire harness just enough to hold everything in place without the need for that ugly annoying clamp. After you slide the part in place carefully screw your guide tube fittings back in and use the 14mm wrench to tighten. If you use a flat wrench there will be just enough of the fitting sticking up above the part to tighten it enough. I did this on purpose as it helps prevent overtightening since the metal it screws into is very brittle. This also makes the part very strong having it a bit thicker on top.

I've printed this in both ABS and PLA however the PLA version is far easier as the ABS version warps easily. Plenty of strength even with the PLA wit