Thingiverse
Bit HOLDER
1
Downloads
0
Likes
0
Makes
Easy bit holder !
Tight enough to keep the bits inside, but also easy to remove the bits.
It can hold 30 bits.
I had to take serval attempts until i got right pressure.
I had to scale it down to 98% of its original size to get the best fitting results.
The print took 1 hour and 20 minutes.
It was printed with PETG DEVIL at 240 celsius
first layer 0,3
line width 0,4
wall line count 3
bottom/top layer 3
infill 10%
bed temp 90 °c
infill speed 90 mm/s
wall speed 60 mm/s
Tight enough to keep the bits inside, but also easy to remove the bits.
It can hold 30 bits.
I had to take serval attempts until i got right pressure.
I had to scale it down to 98% of its original size to get the best fitting results.
The print took 1 hour and 20 minutes.
It was printed with PETG DEVIL at 240 celsius
first layer 0,3
line width 0,4
wall line count 3
bottom/top layer 3
infill 10%
bed temp 90 °c
infill speed 90 mm/s
wall speed 60 mm/s
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!