Blackbeards Dagger

I modeled this dagger after the dagger carried by Taika Waititi's Blackbeard in HBO's Our Flag Means Death for my Edward Teach Blackbeard cosplay! :)

The file only includes one half, and is intended to print in two halves that go together. I would recommend mirroring the other half, as opposed to printing two of the same side (I am an amateur modeler, so I am not sure how exactly straight the piece is). I mirrored my other side and it fit together perfectly.

Blade is very very thin! I did a bit of sanding and used considerable primer and paint, and it spent the whole time inside of the sheath, so it was perfectly fine for me, but you may want to bulk up the z sizing if you want a heftier blade.

The dagger grip is bare. It basically goes down to the "tang" and I used a vinyl wrap to make the grip instead of printing the full grip.

I believe I had to resize it to 90% to make sure it stayed in the more used print area of my bed. If you desire a little bit larger dagger, the f