Slicer Discord
Bookmark – 3D-printbaar model van Thingiverse Thingiverse

Bookmark

door EvaB
7 Downloads
3 Likes
0 Makes
Model downloaden
This model is a bookmark. As you can see, it is not your average bookmark. This bookmark actually points to the word you left off on if you stop in the middle of a page. How it works is, you would insert the pointer into the toothed section of the bookmark with the ledges of the pointer facing the teeth. This allows, or should allow the pointer to slide up and down the bookmark. The other section of the bookmark is so that you can hook it over the page so it stays in place. This helps learning because when students are reading books, they don’t have to waste time finding where they left off. It keeps readers more organized. This was made for mainly students and either reading or language arts teachers.
Bron
Thingiverse
Wat je nodig hebt om te printen: Beginner Lage betrouwbaarheid
Eendelig
Supports 1/3
Montage 0/3
Instellingen 1/3
Bedgrootte 0/3
Nabewerking 0/3
Printer
FDM / FFF
Bestandsformaat
STL
Materiaal
PLA
Software
Cura, PrusaSlicer of vergelijkbaar
Nog geen beoordelingen
Nog geen reacties – wees de eerste!
Feed Blog Slicer Kostenrekenmachine Zoeken op afbeelding Indienen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Toevoegen aan collectie