Thingiverse
Bosch Forward Reverse Switch
von Xiedinian
0
Downloads
0
Likes
0
Makes
IMPORTANT: You may need to sand and file some parts to make it fit right.
I made this to replace a broken switch for my own driver. After sanding it down and filing the middle part, I was able to make it fit.
This piece has been edited so you shouldn't need to file the middle section, but you may need to.
I made this to replace a broken switch for my own driver. After sanding it down and filing the middle part, I was able to make it fit.
This piece has been edited so you shouldn't need to file the middle section, but you may need to.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!