Thingiverse
BOTW Link Shield
by Malonejj24
29
Downloads
28
Likes
0
Makes
Designed the shield from BOTW to be printed on a small bed. Be sure not to print any of the dovetail surfaces ontop of support, the clearance will be off and it will not fit well together (without a LOT of sanding).
For the handle I would reduce the width 1 or 2%, the fit was almost too tight.
Hole sizes are for M10x1.5 bolts, yes they are large, yes I should have used smaller ones.
For the handle I would reduce the width 1 or 2%, the fit was almost too tight.
Hole sizes are for M10x1.5 bolts, yes they are large, yes I should have used smaller ones.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
