Bow Blind Pull

I was moving my daughter into a new room and I discovered that the existing blind pull cord was broken. The bit at the end was missing leaving just a frayed cord. My daughter loves the Hello Kitty Bow (although not the show) so I turned [muzikfreak722's](https://www.thingiverse.com/muzikfreak722/designs) existing [Hello Kitty Bow Box](https://www.thingiverse.com/thing:123941) design into a blind pull as well as a bifold door / drawer pull.

### Bow Blind Pull Cord
- Print off "Bow Blind Pull" and "Plug"

**Printing**
- The Bow Blind Pull Cord has the bow design on both sides. The part that's touching the printing plate will likely need supporst. The hole inside the bow blind does not (at least on my printer it didn't).
- Print at around 40% infill, .2mm layer height
- Printed with PLA+



### Bow Drawer Pull
- Print off "Bow Blind Drawer Pull"

**Printing**
- The Bow Drawer Pull should be printed with the bow facing down towards the print plate. Should be printed with supports