Thingiverse
Bra-Hook
von PhxHoser
2
Downloads
1
Likes
0
Makes
Simple hook for my wife to hang her bra's on.
I used command strips to hold it onto the all to avoid putting holes in the wall. It has been holding strong for a couple of weeks without failure
Once you import into your preferred slicer you will need to increase the scale. I recommend ~600% to for the best size.
I used command strips to hold it onto the all to avoid putting holes in the wall. It has been holding strong for a couple of weeks without failure
Once you import into your preferred slicer you will need to increase the scale. I recommend ~600% to for the best size.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!