Thingiverse
Bracket 13mm Hypercube Evolution
por JoInfoTech
5
Descargas
5
Likes
0
Makes
Se você possui mesa prélo3d ou JMP que a distancia entre furos é de 321x321
vai precisar desse suporte.
SE na sua impressora, o perfil 20x20 mais curto da base da mesa tem 255mm + 20 + 20 = 295 + braket (13+13) = 321mm.
If you have a hotbed where the measure between hole is 321x321 you will need a bracket wif 13mm like this one.
vai precisar desse suporte.
SE na sua impressora, o perfil 20x20 mais curto da base da mesa tem 255mm + 20 + 20 = 295 + braket (13+13) = 321mm.
If you have a hotbed where the measure between hole is 321x321 you will need a bracket wif 13mm like this one.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!