Thingiverse
Brompton front rack
von imchun
45
Downloads
33
Likes
0
Makes
The tubes are 18-19mm carbon fiber tube, glued with epoxy.
I printed the rack with 30% infill PLA.
The fringe of the mount cracked when I tried to carry 5-6 kg stuff on it.
Perhaps you may improve the model.
I borrow the design from here:
https://www.myminifactory.com/object/3d-print-bromton-front-bike-mount-73171
I guess the mount is the only weak point.
I printed the rack with 30% infill PLA.
The fringe of the mount cracked when I tried to carry 5-6 kg stuff on it.
Perhaps you may improve the model.
I borrow the design from here:
https://www.myminifactory.com/object/3d-print-bromton-front-bike-mount-73171
I guess the mount is the only weak point.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!