buttplug

I designed this in tinkercad and it was my first piece in there. mostly just a proof of concept but it turned out pretty good so I figured I'd share. the original size I made it was kind of small so I went with 125% scaling and it prints a nice size. read the dimensions before you slice it and scale to your liking. I found that printing with supports is not necessary on the ender 3. my first print, I ended up breaking the base off while trying to remove the supports. also go with a wall thickness and top/bottom layer of 2mm so it's nice and solid. also this will give you some room if you'd like to sand the edge where the round base meets the cone edge a little smoother. actually, I'd recommend sanding the whole thing down a bit if you plan to use it.