Thingiverse
BX Pi Right Camera Mount
von boonswee
14
Downloads
1
Likes
0
Makes
Print with 10 - 30% infill is fine.
Using Skirt with 0.00mm gap. make it stick better on the bed.
0.2 - 0.28 mm layer height also are fine
Using Skirt with 0.00mm gap. make it stick better on the bed.
0.2 - 0.28 mm layer height also are fine
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
