Thingiverse
Cable clip clamp R-type
von M8kN_B8kN
6
Downloads
7
Likes
0
Makes
If you need more than a few of these, buy them.
I have white nylon clips, but I needed a couple of black ones. This worked.
No supports, no raft, no brim.
Model is 1mm thick, so I set 0.5mm wall thickness.
Scaling to 80% and 120% worked ok with the same wall thickness.
The model has some mismatched beveled edges, but they're not visible in the 0.2mm slice.
I have white nylon clips, but I needed a couple of black ones. This worked.
No supports, no raft, no brim.
Model is 1mm thick, so I set 0.5mm wall thickness.
Scaling to 80% and 120% worked ok with the same wall thickness.
The model has some mismatched beveled edges, but they're not visible in the 0.2mm slice.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
