Cable Clip

I got fed up with my power cable slipping under the table every time I unplugged my laptop, so I created a small part that would let the cable go through relatively easy but prevent it from slipping off the edge of the table.
I was looking for a way to attach the clip to the table that does not involve a complicated mechanism, so I decided to go with press-fit.
To make the holder stay put better, I attached rubber pads to the top and bottom of the clamp, using [Gorilla Glue Gel](https://www.amazon.com/Gorilla-Super-Glue-Gel-Clear/dp/B00CJ5EO2E).

The part is customizable in Fusion 360, I suggest setting these parameters:
TableThikness
CableRadius (please note this is NOT the diameter, but the radius of the cable)
PaddingThikness (if you use some other material than the foam sheet, see the picture)