Thingiverse
Cable conector
door fernandohdzB
39
Downloads
39
Likes
0
Makes
Cable conector for 2.2 mm electric wire
You have to peel 10 mm of each end you want to connect and: 1- bend to inside one the female part and, 2- bend back outside on de male part, the alternate position on the 2 and 3 wires makes very difficult to short circuit at the coupling time,
I been using this on a 125cc pit bike engine to connect to battery and cdi etc. no problems
You have to peel 10 mm of each end you want to connect and: 1- bend to inside one the female part and, 2- bend back outside on de male part, the alternate position on the 2 and 3 wires makes very difficult to short circuit at the coupling time,
I been using this on a 125cc pit bike engine to connect to battery and cdi etc. no problems
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!